Screw compressors as a very useful and important equipment in the industry, in order to increase the efficiency and efficiency of this equipment, it is important to comply with a number of standard and specific rules and regulations regarding the process of repairing the Screw Compressor. To this end, Hyper Industry Famco, as a technical and engineering complex with its experienced staff, has been able to take important steps to repair the screw compressor and restore this vital equipment to the country's industry cycle. Hyper Industry Famco is as follows:
Screw compressor repair due to not turning on
When the Screw Compressor does not turn on, the problem is likely to be related to the electrical parts and circuits attached to the engine. You must first ensure electricity and connect the compressor electrical circuits. Sometimes the power flow may have a low voltage, which is not sufficient to launch the compressor engine. The compressor motor control circuit is used.
Make sure the fuse jumping or failure is the cause of the compressor not turning on.
You should check out the temperature and pressure keys in the screw compressor. These keys also make the compressor not turn on.
If the problem remains, you should go to the compressor engine. .
Fix the problem of shutting down the work of screw compressors
sometimes the compressor turns on; But it suddenly turns off suddenly.
The sudden drop in power voltage is one of the reasons for this.
In addition, be sure to check the wire connections in the compressor to make sure they are firm. > Engine each screw compressor has a specified capacity.
If the input load goes above the permitted surface, the engine will be turned off immediately to prevent damage.
Screw compressor repair due to under load
It is possible for the compressor to turn on; But despite the engine working, we do not see air compression. In this case, the compressor is not loaded.
Air Inlet Valve
Electric Valves
To repair the screw compressor. In this case, you should usually think about replacing the above valves. The valve is not input or electric; it is the compressor pressure switch is adjusted to the upper number. So you need to set the pressure switch to the appropriate number so that the device goes under the load and the air compression process begins.
What are the two main reasons for the failure of a compressor?
Gas Leak
If there is a failure in the compressor floods and wheels, gas leakage may occur. This problem can lead to a decrease in performance and performance of the compressor. To fix this problem, the floods and wheels must be replaced and the system will be reviewed to discover and fix leakage points. It does not provide enough power to compress the gas, it may be less than expected. This problem usually occurs due to the failure of the screw sections or the decrease in the performance of the compressor engine. In this case, the broken sections should be repaired or replaced and the engine's performance check. Be. This problem usually occurs due to the imbalance in the screw sections, the tires and backups, or the inadequate installation of the compressor. To fix this problem, repair parts need to be repaired and adjusted the compressor balance.
High heating
if the compressor is constantly active for a long time or Its cooling system is not effective, the compressor temperature may increase. This problem can reduce the life of the compressor and its impeccable performance. To fix this problem, you need to check the cooling system and, if necessary, repair or replace.
View oil in compressed air
The oil spine is old or saturated with oil.
The volume of the oil is very high.
The operating temperature of the screw compressor is very high
use inappropriate oil
Minimum pressure valve Does not